I don't understand the angled piece as surely that would damage the TPE / Silicone?
It feels that should be a 90 degree angles joint but that would put more pressure on the joint and cause a potential snap where as is there is no single pressure point so I can see why they have done it that way but thats simply protection of the mechanism rather than the girl.
Should there not also be foam between the sharp bottom of the connector and the body? In fact at the base of the connector as well where it gets awfully close to the body, that surely needs some form of foam to protect the body as well espechially during mounting and unmounting.
Not trying to be pedantic. I can see the market for this sort of device. I just think that as is, the connection looks as though it has the potential to inflict some damage especially if used long term such as where used for a girl as a set peice display in a living room / hallway.
I have no doubt that it will do its intended purpose but my concern is for the girls body rather than only the posing.
The person you need to talk to is For Real who is an Engineer so may see the solutions that are needed to improve the design where I am mainly seeing the problems with this.
|