Here's a more detailed shot of this area:
The hole above the labia is carved into the silicone. Below the silicone layer you can see the opening where the penis adapter is screwed into a small metal plate. On the left, you can see a realistically molded vagina that is glued onto the rest of the body.
The silicone used for the body is quite hard, comparable with the silicone used by
Doll Sweet until 2013 and harder than the silicone used in nowadys silicone baking forms. So it's a very strange decision to mold the labiae separately, but still use a hard silicone for the vagina. The looks are OK, but it dosn't feel great.
That's the adapter used to attach the penis to the hermaphrodite:
On top of the labiae, there are slight tears where the labiae are glued into the vaginal opening. Remember, this is a doll fresh from the factory that has never been used!
The doll comes with two cocks be default. This is the small one:
…and this is the big one:
Both cocks side by side:
Both cocks are circumsized and don't have balls. Physiologically this could be considered correct as the male testicles develop from the labiae, if I remember my biology class correctly. However, a cock without balls looks somehow incomplete - it's more a penis-shaped dildo than a penis.
The sizes of the cocks are 16 and 18 cm (length) and 4 respectively 5 cm diameter.
That's the adapter element:
On the left there's a long metal thread that goes into the doll's tummy.
(continued in next post)